What is a plugin Toyota Hybrid, Lexus Hybrid?
This plugin provides advanced functionality for reading and erasing DTCs from the engine control unit as well as from hybrid powertrain control unit, HV battery, ABS, SRS, ESP, EHPS, PPS, Climate controller, Combination meter, Immkbilizer and other systems over K-line and CAN. The plugin also provides an ability to capture up to 200 parameters available when connecting via the OBDII/EOBD standard, and up to 60 parameters from ABS. This plugin supports Prius 10, 11, 20, 30, 40 and other Toyota/Lexus hybrid cars manufactured before 2018.
The number of supported ECUs and parameters for your car depends on many factors. We recommend trying the plugin for free before purchasing it. To test the plugin before purchasing, on the Profile page, create a profile for your Toyota/Lexus hybrid car and connect to the vehicle.
The plugin is enabled if the protocol for Toyota/Lexus hybrid is set in the diagnostic protocol field. The OBDII/ EOBD mode is designed to connect to the car using the basic OBDII/ EOBD protocol without the plugin participation. If you are satisfied with the number of found ECUs, DTCs and parameters, then buy the plugin to remove the ## signs, which hide some values in test mode.
Depending on the vehicle modification, year of manufacture and technical capabilities of your OBD2 scanner (ELM327 adapter), the application can read information from the following blocks:
- hybrid system;
- HV Battery;
- power steering (EMPS/EHPS/PPS);
- anti-lock braking system (ABS);
- smart cruise control;
- power window master switch;
- back door;
- climate / automatic air conditioner
- combination meter;
- network Gateway (PM1);
- parking system (Parking Assist);
- airbags (SRS);
- keyless entry & start;
- Tire Pressure Monitor System (TPMS);
- motor (driver door);
- motor (passenger door);
- motor (rear left door);
- motor (rear right door);
- body control module (BCM 1).